Print Settings Guide
Starting points for every filament we carry. Every printer is a little different, so print a temperature tower or a small test piece and adjust from here.
Quick reference
| Filament | Nozzle | Bed | Speed |
|---|---|---|---|
| iSanmate Gradient PLA+ | 200–230 °C | 45–60 °C | 40–130 mm/s |
| iSanmate Tri-Color Matte PLA | 190–220 °C | 35–60 °C | 30–300 mm/s |
| PolyMaker PolyLite PLA Pro | 190–220 °C | 30–60 °C | 30–70 mm/s |
| PolyMaker PolyLite PETG | 230–240 °C | 70–80 °C | 30–50 mm/s |
Which filament should I pick?
- PLA / PLA+ – the easiest to print. Great for models, decor, cosplay and most everyday prints. PLA+ is tougher and less brittle than standard PLA.
- Matte PLA – same easy printing with a low-sheen finish that hides layer lines. Ideal for display pieces and miniatures.
- PETG – stronger and more heat-resistant than PLA. Choose it for functional parts, outdoor use, or anything that might sit in a hot car.
Troubleshooting
- Stringing – lower the nozzle temperature 5 °C at a time, and make sure the filament is dry.
- Poor bed adhesion – clean the bed with isopropyl alcohol, re-level, and raise the bed temperature 5 °C.
- PETG sticking too hard – use a textured sheet or a thin layer of glue stick as a release layer on smooth PEI.
- Brittle filament or popping sounds – the spool has absorbed moisture. Dry PLA at about 50–55 °C and PETG at about 65 °C for 6 hours.
Storage
All filament absorbs moisture from the air. Store open spools in a sealed bag or box with desiccant, and keep them out of direct sunlight.